The powder coating spray gun can not work 2

Cause: worn-down sleeve

Solve way:Replace

Cause:CONVERYING AIR is not supplied.

Solve way:check above issues

Cause:Faulty air –adjustment valve

Solve way:Replace

Cause :Faulty solenoid valve

Solve way:Replace

Cause:Faulty PCB

Solve way:Replace

Cause:Oil and moisture contained In the compressed air 

Solve way:Install an air dehydrator

2. Problem:Powder is ejected from GUN but with its electrostatic intensity low

Cause:High-voltage assembly is low

Solve way:increase the voltage levera

Cause:Faulty GUN connector , wire and wire connector

Solve way:Replace the faulty part

Cause:Faulty high-voltage cascade

Solve way:Replace

Cause:Faulty PCB

Solve way:Replace

Cause:Faulty ROD holder

Solve way:Replace

3. Problem:Powder ejection and electrostatic intensity is good , but its attach efficiency is poor

Cause:Faulty earth of powder object

Solve way:Check the earth state

Cause:Too much paint on the conveyor hangar and powder object area

Solve way:Remove powder from hand and powder-object area

Cause:The high voltage pin caved in

Solve way:Replace the rod holder